Laguna Tools MPLAN1510-0120 Manual page 57

Power drive cover removed
5. Remove the power drive cover.
6. Check that the chain tension wheel is free to move and that the chains are clean
and lubricated.
7. Reassemble.
Lubricating the machine.
Lubrication oil to be added every 30 hours of
operation, to both sets of holes as shown.
Note. All the bearings are sealed for life and
do not require lubrication. If a bearing is
noisy, do not try to re-lubricate but replace it.
Note. It is recommended that you use a
Teflon-based lubricant, as it tends to dry and
therefore will attract less sawdust and dirt.
Lubricate the drive chains and cogs.
Drive roller and anti-kickback teeth
adjustment.
The drive roller pressure roller and
anti- kickback teeth must sit below the
cutter head teeth.
The drive roller and pressure rollers
are sprung loaded and as the wood
passes move vertically. This provides
the correct amount of pressure to
transport the wood past the cutter
head and keep the wood firmly in
contact with the bed of the machine.
Chain tension wheel
Lubrication holes
Pressure roller
Drive roller Anti-kick back teeth
Cutter head
21