Laguna Tools MPLAN1510-0120 Manual page 22

The drive roller, pressure roller and anti-
kickback teeth come factory set but should
adjustment be required proceed as follows.
Loosen the lock nut and move the adjusting
screw. Remember to tighten the lock nut once
the adjustment has been completed.
Note. There is a screw both sides of the
machine for both rollers [four adjusting screws
in total]. If parallel adjustment is required both
screws must be moved the same amount for
each roller.
To adjust for parallel it is suggested that a block
Lock nut Adjusting screw
of parallel wood is used and placed under the
relevant roller at one end. The bed of the machine is then moved vertically so that
the wood just touches the relevant roller. Check both sides of the roller that you are
adjusting.
22