Operation - MULTIQUIP V305EH Operation And Parts Manual

GEARBOX LUBRICATION
1. Remove the oil fill drain plug on the gearbox (Figure 15). If
the oil level is correct, oil will begin to leak out. Retighten
drain plug.
Figure 15. Gearbox Fill and Drain Plugs
2. If the level of the oil in the gearbox is low, no oil will leak
out when the drain plug is removed. Add gearbox oil, type
SAE 90, through this drain opening. Fill until oil begins
to leak out from the drain opening. Retighten drain plug.
It is recommended that oil be changed every 300 hours
of operation.
HANDLE BAR ADJUSTMENT
1. Adjustment of the handle bar is made by removing
the handle bar hitch pin, then pulling the release pin.
2. Once released pin has been removed, position handle
bar to desired height (Figure 16 and Figure 17).
3. Insert release pin and lock with hitch pin.
PAGE 22 — V305EH VIBRATORY ROLLER • OPERATION AND PARTS MANUAL — REV. #1 (06/21/16)
GEARBOX
FILL PLUG
AND
LEVEL CHECK
GEARBOX
DRAIN PLUG
INSPECTION
HITCH PIN
1. PARK POSITION
2. HIGH POSITION
3. MIDDLE POSITION
3. LOW POSITION
Figure 16. Handle Positions 1
POSITION 1 (PARK)
Figure 17. Handle Positions 2
HANDLE
BAR
RELEASE
PIN
POSITION 2
(HIGH)
POSITION 2
(MIDDLE)
POSITION 2
(LOW)