Important Safety Instructions - Champion Power Equipment 100310 Operator's Manual

100310 - 3000 PSI PRESSURE WASHER

IMPORTANT SAFETY INSTRUCTIONS

The engine exhaust from this product contains chemicals
known to the State of California to cause cancer and birth
defects and other reproductive harm.
This product contains chemicals known to the State of
California to cause cancer and birth defects and other
reproductive harm.
Engine exhaust contains carbon monoxide, a colorless,
odorless, poison gas. Breathing carbon monoxide will cause
nausea, dizziness, fainting or death. If you start to feel dizzy
or weak, get to fresh air immediately.
Operate this product outdoors only in a well ventilated area.
DO NOT operate the product inside any building, including
garages, basements, crawlspaces and sheds, enclosure or
compartment, including a compartment of a recreational
vehicle.
DO NOT allow exhaust fumes to enter a confined area
through windows, doors, vents or other openings.
DANGER: CARBON MONOXIDE – using this product indoors
CAN KILL YOU IN MINUTES.
Rotating parts can entangle hands, feet, hair, clothing and/
or accessories.
Traumatic amputation or severe laceration can result.
Keep hands and feet away from rotating parts.
Tie up long hair and remove jewelry.
Operate equipment with guards in place.
DO NOT wear loose-fitting clothing, dangling drawstrings or
items that could become caught.
Contact with electrical power source can cause electric
shock or burn.
NEVER spray in the direction of or near a power source/
electrical outlet.
WARNING
WARNING
DANGER
DANGER
WARNING
IMPORTANT SAFETY INSTRUCTIONS
WARNING
Sparks can result in fire or electrical shock.
When servicing the pressure washer:
Disconnect the spark plug wire and place it where it cannot
contact the plug.
DO NOT check for spark with the plug removed.
Use only approved spark plug testers.
WARNING
Running engines produce heat. Severe burns can occur on
contact. Combustible material can catch fire on contact.
DO NOT touch hot surfaces.
Avoid contact with hot exhaust gases.
Allow equipment to cool before touching.
Maintain at least 91.4 cm (3 ft.) of clearance on all sides to
ensure adequate cooling.
Maintain at least 1.5 m (5 ft.) of clearance from combustible
materials.
DO NOT let water in the pump freeze.
See Storage section in the manual for instructions regarding
winter storage.
If water has frozen in the pressure washer, thaw the
pressure washer in a warm room before starting.
DO NOT pour hot water on or into the pump; internal parts
will be damaged and your warranty will be voided.
NEVER run the unit dry.
Be sure the water supply is completely turned on before
operating the unit.
NOTICE
NOTICE
5