Configuring EtherChannels
When the interface joins an EtherChannel, the following individual parameters are replaced with the values
on the EtherChannel:
• Bandwidth
• MAC address
• Spanning Tree Protocol
The following interface parameters remain unaffected when the interface joins an EtherChannel:
• Description
• CDP
• LACP port priority
• Debounce
After you enable forcing a port to be added to a channel group by entering the channel-group force command,
the following two conditions occur:
• When an interface joins a port channel the following parameters are removed and they are operationally
replaced with the values on the port channel; however, this change will not be reflected in the
running-configuration for the interface:
• When an interface joins or leaves a port channel, the following parameters remain unaffected:
• QoS
• Bandwidth
• Delay
• STP
• Service policy
• ACLs
• Beacon
• Description
• CDP
• LACP port priority
• Debounce
• UDLD
• Shutdown
• SNMP traps
Cisco Nexus 3000 Series NX-OS Layer 2 Switching Configuration Guide, Release 5.0(3)U1(1)
Compatibility Requirements
57