Port Priority; Rapid Pvst+ And Ieee 802.1Q Trunks - Cisco Nexus 3000 series Configuration Manual

Rapid PVST+ and IEEE 802.1Q Trunks

Table 10: Default Port Cost
Bandwidth
10 Mbps
100 Mbps
1 Gigabit Ethernet
10 Gigabit Ethernet
You can assign lower cost values to LAN interfaces that you want STP to select first and higher cost values
to LAN interfaces that you want STP to select last. If all LAN interfaces have the same cost value, STP puts
the LAN interface with the lowest LAN interface number in the forwarding state and blocks other LAN
interfaces.
On access ports, you assign port cost by the port. On trunk ports, you assign the port cost by the VLAN; you
can configure the same port cost to all the VLANs on a trunk port.

Port Priority

If a loop occurs and multiple ports have the same path cost, Rapid PVST+ considers the port priority when
selecting which LAN port to put into the forwarding state. You can assign lower priority values to LAN ports
that you want Rapid PVST+ to select first and higher priority values to LAN ports that you want Rapid PVST+
to select last.
If all LAN ports have the same priority value, Rapid PVST+ puts the LAN port with the lowest LAN port
number in the forwarding state and blocks other LAN ports. The possible priority range is from 0 through
224 (the default is128), configurable in increments of 32. software uses the port priority value when the LAN
port is configured as an access port and uses VLAN port priority values when the LAN port is configured as
a trunk port.
Rapid PVST+ and IEEE 802.1Q Trunks
In a network of Cisco switches connected through 802.1Q trunks, the switches maintain one instance of STP
for each VLAN allowed on the trunks. However, non-Cisco 802.1Q switches maintain only one instance of
STP for all VLANs allowed on the trunks.
When you connect a Cisco switch to a non-Cisco switch through an 802.1Q trunk, the Cisco switch combines
the STP instance of the 802.1Q VLAN of the trunk with the STP instance of the non-Cisco 802.1Q switch.
However, all per-VLAN STP information that is maintained by Cisco switches is separated by a cloud of
non-Cisco 802.1Q switches. The non-Cisco 802.1Q cloud that separates the Cisco switches is treated as a
single trunk link between the switches.
Cisco Nexus 3000 Series NX-OS Layer 2 Switching Configuration Guide, Release 5.0(3)U1(1)
88
Short Path-cost Method of Port
Cost
100
19
4
2
Configuring Rapid PVST+
Long Path-cost Method of Port Cost
2,000,000
200,000
20,000
2,000