Warnings
WARNING: Observe extreme caution when a defibrillator is in use. Do
WARNING: Do not leave the patient unattended for long periods of time
WARNING: Use only approved accessories with this product. Use of
WARNING: This instrument may have trouble obtaining pulse rate and
WARNING: Wrapping the cuffs too tightly may cause a hazard to the
WARNING: Only connect cuffs with approved quick connect type
WARNING: The Accutorr Plus is not intended for use in a magnetic
WARNING: Do not incinerate battery, possible explosion may occur.
WARNING: Route cables neatly. Ensure cables, hoses and wires are
WARNING: Do not use a damaged or broken unit or accessory.
WARNING: Do not clean the monitor while it is on and/or plugged in.
WARNING: Operation of the Accutorr Plus below the minimum
WARNING: Use of ACCESSORIES, transducers and cables other than
WARNING: The Accutorr Plus should not be used adjacent to or stacked
WARNING: Perform the decontamination or cleaning process with the
WARNING: When attached to other products ensure that the total
WARNING: Use only authorized accessories. Use of unauthorized
WARNING: It is essential that a single use disposable probe cover is
Accutorr Plus™ Operating Instructions
not touch any part of the patient, table or monitor when a
defibrillator is in use.
while using this instrument.
other accessories may result in erroneous readings.
NIBP readings on patients undergoing intra-aortic balloon
pump treatment.
patient.
connectors.
resonance imaging (MRI) environment and may interfere
with MRI procedures.
kept away from patient's neck to avoid strangulation. Keep
floors and walkways free of cables to reduce risk to
hospital personnel, patients and visitors.
amplitude or value of PATIENT physiological signal may
cause inaccurate results.
those specified in the manual may result in increased
Electromagnetic Emissions or decreased Electromagnetic
Immunity of the Accutorr Plus. It can also cause delayed
recovery after the discharge of a cardiac defibrillator.
with other equipment. If adjacent or stacked use is
necessary, the Accutorr Plus should be observed to verify
normal operation in the configuration in which it will be
used.
unit powered down and power cord removed.
chassis leakage currents of all units (combined) do not
exceed 300µa.
accessories may result in erroneous measurements.
used when taking temperature measurements.
0070-10-0692-02
Introduction
vii
Need help?
Do you have a question about the accutorr plus and is the answer not in the manual?