Error Messages - RMG EC 24 Operating Instructions Manual

...........................................................................................................................................................................................................

Error messages

In coordinate G 01 error messages are displayed as error number followed by "Err".
The messages no. 1 to 8 are fault messages. In this case the main totalizers stop and the disturbing
quantity totalizers start to run. The messages no. 9 to 16 are warnings and have no effect on the
totalizers.
Error no.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
In the column "Hexadecimal" the error bit strings displayed in coordinate Z 09 are listed.
...........................................................................................................................................................................................................
Manual EC 24 · EN05 · 2015-02
Hexadecimal Description
0x0001 Parameters in EEPROM are wrong (may be wrong version)
0x0002 EEPROM can not be written (parameters are lost)
0x0004 Analog digital converter for temperature measurement
0x0008 Analog digital converter for pressure measurement
0x0010 Sensor failure
0x0020 Measured temperature outside limits
0x0040 Measured pressure outside limits
0x0080 Hardware and software configuration do not fit
0x0100 Tamper contact
0x0200 Error during GERG calculation
0x0400 Error in flow rate measurement
0x0800 Error in monthly data logger
0x1000 Current output
0x2000 Too many output pulses in buffer (>500)
0x4000 Sensor defect (check hardware)
0x8000 Sensor defect (check hardware)
OPERATION
27