Programming - RMG EC 24 Operating Instructions Manual

...........................................................................................................................................................................................................

Programming

Via the programming keys
For programming the EC 21 / EC 24, there are four buttons on the rear side of the board. The
official parameters are protected by a calibration switch and a password.
Via the programming module
Instead of using to the programming keys, you can program the device using the programming
module. The programming module is to be connected via a pin connector (see the picture below).
P
Programming
module
Programming with the programming module is to be performed in the same way as with the internal
buttons.
...........................................................................................................................................................................................................
Manual EC 24 · EN05 · 2015-02
X6_0
CX2
X5
CX3
CX1
X7
RESET
Taster
X151
Programming
keys
OPERATION


-
+
P
15