Operating Program; Time Program - Viessmann VITOCROSSAL 300 Operating Instructions Manual
Ca3 series 2.5, 3.0, 3.5, 4.0, 5.0 and 6.0
with vitotronic 300 gw6c control
2500 to 6000 mbh (733 to 1758 kw)
Hide thumbs
Also See for VITOCROSSAL 300:
- Service instructions manual (164 pages) ,
- Service instructions for contractors (148 pages) ,
- Service manual (108 pages)
Table of Contents
Advertisement
Central Heating
Operating Program
Time Program
22
Vitocrossal 300 CA3 Series 2.5 to 6.0 Operating
Note: Further information can be found in chapter
"Terminology" in this manual.
Setting the operating program
You can make the following settings only at the system
and lead control boiler section 1.
From the home screen tap the following buttons:
1. "Menu"
2. "Heating"
3. "Heating circuit 1", "Heating circuit 2" or "Heating
circuit 3" as the required heating circuit
4. "Operating program"
5. Select "Operating program", e.g. "Heating and DHW"
6. Press OK to confirm
Note: Further information can be found in chapter
"Terminology" in this manual.
You can make the following settings only at the system
and lead control boiler section 1.
Setting a time program
Factory setting: One time phase from 12:00 am and
12:00 am (00:00 to 24:00 h) for every day of the week
From the home screen tap the following buttons:
1. "Menu"
2. "Heating"
3. "Heating circuit 1", "Heating circuit
2" or "Heating circuit 3" as the required heating circuit
4. "Time program heating"
Procedure for setting a time program, see page 14
Note: When adjusting the setting, bear in mind that your
heating system requires some time to heat the
rooms to the required temperature.
Advertisement
Table of Contents
