The Dhw Is Too Hot; Fault" Will Be Displayed; Service" Will Be Displayed - Viessmann VITOCROSSAL 300 Operating Instructions Manual
Ca3 series 2.5, 3.0, 3.5, 4.0, 5.0 and 6.0
with vitotronic 300 gw6c control
2500 to 6000 mbh (733 to 1758 kw)
Hide thumbs
Also See for VITOCROSSAL 300:
- Service instructions manual (164 pages) ,
- Service instructions for contractors (148 pages) ,
- Service manual (108 pages)
Table of Contents
Advertisement
Troubleshooting
The DHW is Too Hot
Cause
The control unit is set incorrectly.
The DHW is being heated by the solar thermal system.
Emissions test switch is set to
"Fault" will be Displayed
Cause
Heating system fault.
"Service" will be Displayed
Cause
The time for a service, as specified by your heating
contractor, has arrived.
40
. (see page 37)
Vitocrossal 300 CA3 Series 2.5 to 6.0 Operating
Remedy
Check and correct the DHW temperature, if required
(see page 27).
Check the settings at the solar control unit and correct
them if required.
Separate operating instructions
Set the emissions test switch to position
Remedy
Proceed as described on page 33.
Remedy
Proceed as described on page 32.
.
Advertisement
Table of Contents
