Viessmann VITOCROSSAL 300 Operating Instructions Manual page 32
Ca3 series 2.5, 3.0, 3.5, 4.0, 5.0 and 6.0
with vitotronic 300 gw6c control
2500 to 6000 mbh (733 to 1758 kw)
Hide thumbs
Also See for VITOCROSSAL 300:
- Service instructions manual (164 pages) ,
- Service instructions for contractors (148 pages) ,
- Service manual (108 pages)
Table of Contents
Advertisement
Scanning
Scanning Information
32
(continued)
Vitocrossal 300 CA3 Series 2.5 to 6.0 Operating
Resetting data
You can reset the following data:
H Burner hours run
H Fuel consumption
H In conjunction with a solar thermal system:
Solar energy yield, solar circuit pump hours run
and hours run output 22
H All the above data simultaneously
From the home screen tap the following buttons:
1. "Menu"
2. "Information"
3. "Reset data"
4. Select required data point or "All details".
5. Tap OK to confirm
Scanning service messages
Your heating contractor can set service intervals (limits)
(for burner hours run, for example). A service message
is generated when this value is exceeded.
Your display indicates that your heating system is due
for a service by showing symbol
Tap "Confirm".
The footer shows
.
Calling up a service message
1. Tap
in the footer.
The service message will be listed in yellow.
2. Notify your local heating contractor.
After tapping
the following will be displayed if
your heating system has several fault messages
simultaneously:
Tap "Service messages"
The service message will be listed in yellow.
Note: If the service cannot be carried out until a later
date, the service message will be displayed again
the following Monday.
and "Service".
Advertisement
Table of Contents
