Cisco Nexus 9000 Series Configuration Manual page 248

Deactivating and Removing Packages
Procedure
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Cisco Nexus 9000 Series NX-OS System Management Configuration Guide, Release 6.x
228
Command or Action
Connect to the console port and log in.
reload module standby-sup-slot
Example:
switch# reload module 2
install deactivate filename
Example:
switch# install deactivate
n9000-dk9.6.1.2.I2.1.CSCab00001.bin
show install inactive
Example:
switch# show install inactive
install commit
Example:
switch# install commit
install remove {filename | inactive}
Example:
switch# install remove
n9000-dk9.6.1.2.I2.1.CSCab00001.bin
Proceed with removing
n9000-dk9.6.1.2.I2.1.CSCab00001.bin?
(y/n)? [n] y
Example:
switch# install remove inactive
Proceed with removing? (y/n)? [n] y
Performing Software Maintenance Upgrades
Purpose
Establishes a CLI management session to the console
port.
Reloads the standby supervisor module, if installed.
If you are deactivating the SMU package in a
Note
dual-supervisor system and your device is
running Cisco NX-OS Release 6.1(2)I2(3) or
a software release prior to Cisco NX-OS
6.1(2)I2(2b), you must reload the standby
supervisor module.
Deactivates a package that was added to the device and
turns off the package features for the line card.
(Optional)
Displays the inactive packages on the device.
(Optional)
Commits the current set of packages so that these
packages are used if the device is restarted.
Note Packages can be removed only if the
deactivation operation is committed.
(Optional)
Removes the inactive package.
• Only inactive packages can be removed.
• Packages can be removed only if they are
deactivated from all line cards in the device.
• The package deactivation must be committed.
• To remove a specific inactive package from a
storage device, use the install remove command
with the filename argument.
• To remove all inactive packages from all nodes
in the system, use the install remove command
with the inactive keyword.