CraftUnique CraftBot Desktop User Manual page 4

RECOMMENDED USE AND WARNINGS
*The CraftBot should be operated on a flat and even surface parallel with the
ground.
*CraftBot should never be used in high traffic footpaths, or any footpath or walk-
way for that matter. It should not be used in any area were any outside interfer-
ence to the unit could occur.
*Keep small children away from the CraftBot printer, as moving parts could be at-
tractive to them. Although, children can receive great educational benefits from
CraftWare and the CraftBot 3D printer, the mechanism itself is not a toy, but rather
it is a tool. Serious injuries can result if CraftBot is not regarded in this way. Always
keep close watch around any child in the area of the printer, and provide the cor-
rect supervision to avoid any possible injuries. Children are encouraged to work
with the software end of 3D printing, but when it comes to using the CraftBot itself,
an adult should always be there.
*Take care of all pets in the area of the CraftBot 3D printer. Especially with cats, as
the moving parts can be very enticing. The components have the ability to cause
serious harm, and just as a human should not reach inside the printer while in op-
eration, neither should an animal.
*Do not place the CraftBot 3D printer on top of any moving devices.
*Never place anything on top of the printer. There are many moving parts in the
printer and setting objects on top of it could lead to unnecessary dangers in the
environment, such as things falling off the top of the printer, or into the printer it-
self.
*Never place the printer near an open flame, water, heat sources, flammable ma-
terials, or anything else deemed "hazardous".
*Always work with a smoke alarm in the same room as the CraftBot 3D printer.
4 Recommended use and warnings