Advertisement
Quick Links
Advertisement
Related Manuals for CraftUnique CraftBot XL
Summary of Contents for CraftUnique CraftBot XL
- Page 1 CraftBot PETG DOME COVER INSTALLATION MANUAL...
- Page 2 CraftBot HARDWARE 1. First, unplug the machine. Then, care- fully remove the rear panel of the printer, using care with the case fan ca- ble (red-black-yellow). Place the dome cover on top of the machine, but do not screw it together yet. 2.
- Page 3 CraftBot 3. Connect the appropriate end of the “Y” wire of the dome cover fan to the case fan socket. 4. After that, connect the case fan con- nector to the other end of the “Y” wire.
- Page 4 CraftBot 5. Finally, screw in the rear panel and the dome cover. The correct location of the filament guide tube and the fan wiring are shown in the following figures. FIRMWARE SETTINGS • In the temperature setting menu, by pressing the icon, the dome cover settings menu will be displayed.
Need help?
Do you have a question about the CraftBot XL and is the answer not in the manual?
Questions and answers