Dial Mode (Cordless Handset Only); Flash Time - Amplicomms PowerTel 1880 User Manual

3. Select CID time sync and press SELECT on the corded phone
or press
4. Select On or Off and press SELECT on the corded phone or
press

Dial mode (cordless handset only)

The standard dialling mode for analogue phones is "touch-
tone". On some older phone systems the dialling mode must
be set to "pulse". Please see your phone system's user guide
for more information.
1. In idle state press the menu key
2. Select Settings and press
3. Select Dial mode and press
4. Select Touch-tone or Pulse and press

Flash time

The use of supplementary services requires a flash signal of
a specific length. You can obtain information about available
supplementary services and the required flash time from
your telephone service provider.
1. In idle state press the menu key
2. Select Settings and press SELECT on the corded phone or
press
3. Select Flash time and press SELECT on the corded phone or
press
4. Select Short, Medium or Long and press SELECT on the
corded phone or press
40
Helpline 0844 800 6503 (See page 51 for costs and hours of operation)
on the cordless handset.
on the cordless handset.
on the cordless handset.
on the cordless handset.
.
.
.
or
on the cordless handset.
.
.