Power Connector - HP Omen series Maintenance And Service Manual

1. Carefully place the system board face down.
2. Insert a thin plastic tool (1) to lift the RTC battery, and then remove the battery (2).
Reverse this procedure to install the RTC battery.

Power connector

Description
Power connector (includes cable)
IMPORTANT:
and replacement.
Before removing the power connector, follow these steps:
1. Shut down the computer.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the base enclosure (see
5. Remove the battery (see
a. Hard drive (see
b. SSD (see
c. Fans (see
d. System board (see
56 Chapter 5 Removal and replacement procedures for authorized service provider parts
Make special note of each screw and screw lock size and location during removal
Base enclosure on page
Battery on page
Hard drive on page
SSD (M.2) on page 41).
Fans on page 48).
System board on page
32).
34), and then remove the following components:
39).
53).
Spare part number
858021-001