Ssd (M.2) - HP Omen series Maintenance And Service Manual

SSD (M.2)

Description
Generic SSD 128 GB 2280 M2 SATA-3 Value TL
Generic SSD 256 GB 2280 M2 PCIe 3x4SS NVMe TLC TL
Generic SSD 512 GB 2280 M2 PCIe3x4SS NVMe TLC TL, not for products with AMD Radeon hybrid
graphics
Before removing the SSD, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the base enclosure (see
5. Disconnect the battery (see
Remove the SSD:
1. Remove the Phillips M2.0 x 2.5 screw (1) that secures the SSD to the system board.
2. Remove the SSD (2) by pulling the drive away from the slot at an angle.
Reverse this procedure to install the SSD.
Base enclosure on page
Battery on page 34).
32).
Component replacement procedures
Spare part number
827560-027
847109-008
847110-007
41