Replacing Printed Circuit Board A - ELNA Star Edition Service Manual

REPLACING PRINTED CIRCUIT BOARD A

TO REMOVE:
1. Remove the front cover (see pages 6, 7).
2. Pull out connectors from the circuit board-A (see page 21).
3. Loosen 7 setscrews and remove the circuit board-A.
TO INSTALL:
4. Follow the above procedures in reverse.
NOTE:
Do not disconnect the connectors by pulling on cord.
To disconnect, grasp the connector, not the cord.
Circuit board-A
Setscrew Setscrew
Setscrew
Setscrew Setscrew
Setscrew
Setscrew
25