Janam XT2 User Manual page 62

Regulatory and Maintenance
Compliance with Part 15 of FCC Rules
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
If necessary, the user should consult the dealer or an experienced radio/television technician
for additional suggestions. The user may find the following booklet helpful: "Something about
Interference." This is available at FCC local regional offices. Our company is not responsible
for any radio or television interference caused by unauthorized modifications of this equipment
or the substitution or attachment of connective cables and equipment other than those
specified by our company. The correction is the responsibility of the user. Use only shielded
data cables with this system.
This device and its antenna must not be co-located or operating in conjunction with any other
antenna or transmitter. To maintain compliance with the FCC RF exposure guidelines for body-
worn operation, do not use accessories that contain metallic components other than specified
by the manufacturer.
Janam Technologies LLC Version 3, April 2017
XT2 User Manual
Regulatory and Maintenance 15—3