Jeep KJ 2005 Service Manual page 1421

9 - 176 2.8L COMMON RAIL DIESEL ENGINE
2.8L COMMON RAIL DIESEL ENGINE (Continued)
Fig. 11 EXHAUST AT TURBO
1 - EXHAUST PIPE
2 - TURBOCHARGER
3 - BRACKET
4 - ENGINE OIL COOLER
(40) Remove exhaust inlet pipe retaining bolts and
disconnect exhaust pipe from turbocharger (Fig. 11).
(41) Remove transmission to engine retaining
bolts.
(42) Separate transmission cooler line(s) from
retainer.
(43) Remove both right and left side engine mount
retaining nut.
(44) Lower vehicle.
(45) Remove left side engine mount retaining nut.
(46) Remove exhaust manifold rear heat shield.
(47) Disconnect the fuel supply and return lines.
(48) Remove crankshaft sensor heat shield.
(49) Disconnect crankshaft position sensor, located
on the right rear of the engine (Fig. 12).
(50) Remove the oil separator from the cylinder
head cover/intake manifold (Fig. 13).
(51) Connect a suitable lifting device to engine
assembly.
(52) Place a floor jack under the transmission to
support the transmission.
(53) With engine and transmission supported by a
lifting device separate the engine from the transmis-
sion.
(54) Lift the engine assembly out of the engine bay
(Fig. 14).
Fig. 12 CRANKSHAFT POSITION (CKP) SENSOR
REMOVAL/INSTALL
1 - RETAINING BOLT
2 - WASHER
3 - CRANKSHAFT POSITION (CKP) SENSOR
4 - ENGINE BLOCK
Fig. 13 OIL SEPARATOR
1 - OIL SEPARATOR
2 - O-RING(S)
3 - CYLINDER HEAD COVER
4 - BOLT (S)
KJ