Co Check - PIAGGIO X8 125 Workshop Manual

Maintenance
Proceed as follows:
1. Position the unloaded scooter, in running order
and with the tyres inflated to the prescribed pres-
sure, on a flat surface 10 m away from a half-lit
white screen; ensure that the longitudinal axis of
the scooter is perpendicular to the screen;
2. Turn on the headlight and check that the bor-
derline of the projected light beam should be lower
than 9/10 of the distance from the ground to the
centre of the vehicle's headlight, and higher than
7/10;
3. If not, adjust the projection by turning the central
screw «A» set inside the glove box.
N.B.
THE ABOVE PROCEDURE COMPLIES WITH THE EURO-
PEAN STANDARDS REGARDING MAXIMUM AND MINI-
MUM HEIGHT OF LIGHT BEAMS. REFER TO THE STATU-
TORY REGULATIONS IN FORCE IN EVERY COUNTRY
WHERE THE VEHICLE IS USED.

CO check

Preparing the vehicle
- Remove the 2 bottom sides as explained in the
Body chapter.
- Remove the 3 fastening screws of the filter box.
- Remove the filter box to access the 6 screws M6
closing the crankcase and the heat guard plate at-
tachments.
- Remove the plate to access the flow adjustment
screw on the carburettor.
- Remove the gas cap on the exhaust pipe.
- Using the original washer, install the exhaust gas
collection Kit union.
- Suitably orientate the components (Figure 2).
- Close the gas outlet terminal of the tool. - Start
the engine and let it warn until the electric fan
starts.
- Stop the engine.
- Disconnect the vacuum feeding pipe from the
SAS control valve.
MAIN - 50
X8 125-200