Pin Retaining Collar; Removing The Driven Half-Pulley Bearing - PIAGGIO X8 125 Workshop Manual

Engine

Pin retaining collar

- Simultaneously turn and pull the collar manually
to remove it.
N.B.
USE TWO SCREWDRIVERS IF YOU HAVE ANY DIFFICUL-
TY.
N.B.
BE CAREFUL NOT TO PUSH THE SCREWDRIVERS IN TOO
FAR TO AVOID DAMAGE THAT COULD COMPROMISE
THE O-RING SEAL.
- Remove the 4 torque server pins and pull the
pulley halves apart.

Removing the driven half-pulley bearing

- Check there are no signs of wear and/or noisi-
ness; - Replace with a new one if there are.
- Remove the retaining ring using two flat blade
screwdrivers.
- Support the pulley bushing adequately from the
threaded side using a wooden surface.
- Using a hammer and pin, knock the ball bearing
out as shown in the figure.
- Support the pulley properly using the bell as shown in the figure.
Specific tooling
001467Y035 Belle for OD 47-mm bearings
ENG - 98
X8 125-200