Premium Leisure Sterling Leisure Owner's Manual page 57

MESSAGE MEANING
SbY Hot tub is in standby mode
PHL pH is low
PHH pH is high
SAL Sanitizer is low
SAH Sanitizer is high
drn
Pump is on during Standby
mode to assist in draining
the water
rtC Hardware failure
PSt
Hardware failure
CrC
Firmware install problem
CFE Configuration error. Hot tub
cannot start up
9FI Could not trip GFCI
StU Pump appears to be stuck
on
HOt Pump was stuck on the last
time it was powered on
Reminder Messages
Message
rPH
rSA
rCL
rt9
rdr
rCO
rtr
rCH
rCA
Frequency Action Required
7 days Test and adjust pH chemical levels.
7 days Test and adjust sanitizer chemical levels.
30 days Remove, clean, and reinstall filter.
30 days Test & reset GFCI breaker.
90 days Drain and refill hot tub.
180 days Clean and condition cover.
180 days Clean and condition exterior surfaces.
365 days Install new filter.
As needed Install new Mineral cartridge.
For HELP, call 727.573.9611
ACTION REQUIRED
Press any button except Jets 1 to
leave Standby mode.
Add pH increaser (pH up)
Add pH decreaser (pH down)
Add sanitizer
Remove hot tub cover and allow
sanitizer to evaporate
Press Jets 1 to turn off pump once
the water has drained out
Contact customer service
Contact customer service
Contact customer service if this
message appears on more than
one power up
Contact customer service
Contact customer service and do
not use the hot tub.
Contact customer service and do
not use the hot tub
Contact customer service and do
not use the hot tub
Page 57