Premium Leisure Sterling Leisure Owner's Manual page 23

Before Adding Water
Before adding water, go through these simple steps now to prevent common
issues when setting up your
have all been rechecked.
1. Turn off all power to the
2. Open the side panels to access the internal components.
3. Check that all slide valves are opened (T-
handles pulled out) to the heater and all
pumps.
4. Check that there are no obvious signs of
loose wires or broken pipes.
5. Check that the two heater
unions are hand tight.
Caution: Do not use a wrench.
Over-tightening may
cause damage to
unions and gaskets,
which will not be
covered under
warranty.
6. Check that the unions on all pumps are tight.
7. Clean out any foreign debris from within the service access area or inside of
the hot tub itself.
8. With the drain open and filters removed, thoroughly rinse out the
warm water until the drained water runs clear. Run water through the
filtration canister and jet lines to remove any incidental dust, dirt, and debris
that may have accumulated during shipment or installation. Drain all water
completely.
9. Make sure that the
page 59).
10. Install the filter(s) in the filtration canister.
11. Check that all of the
12. Now is the best time to clean and polish the surfaces of your
page 60).
hot tub for the first time. Verify that the following
hot tub at the main breaker panel.
hot tub drain valve is closed and the cap is on tight (see
hot tub jets are open (turned full counter-clockwise).
Page 23
For HELP, call 727.573.9611
Figure 16 - Valve Open/Closed
Figure 17 - Unions Tight (Balboa –
Above Top; IN.PL – Above Bottom)
hot tub with
hot tub (see