Premium Leisure Sterling Leisure Owner's Manual page 27

Operational Checks, Passion, Essence, Desire, Pure, Pristine
Caution: Do not turn on any pump until your hot tub is properly filled with
water. Running any pump without water in your hot tub can cause
IMMEDIATE damage, which is not covered under warranty!
By now you have rechecked your hot tub's mechanical connections and filled it
with water to about 1" above all jets by adding cold tap water through the pre-
filter (if equipped). Turn on power to the hot tub at the main breaker panel and
test the operation of the electrical system. If you encounter a problem, please
reference the troubleshooting guide on page 49.
1. Turn on the breaker and test the operation of the Ground-Fault Circuit
Interrupter (GFCI) breaker by pushing the small button. This should
automatically trip the hot tub's circuit breaker.
DANGER: If this breaker does not trip, immediately call your electrician.
Only if pushing this button successfully trips this circuit breaker should you
reset this breaker and proceed to the next step.
2. Go to the topside control panel. The hot tub first goes into a 6-minute
Priming mode, indicated by "Pr" message. Water heating is disabled during
priming. To exit Priming mode and begin normal hot tub operation, press
"Up" or "Down" button. The circulation pump starts and water flows through
the returns.
3. Press the Jets 1 button. You should hear the pump turn on, see water
circulating, and see the Jets 1 light illuminate on the panel.
4. Press the Jets 1 button again. You should hear the pump turn on a higher
speed.
Caution: If water is not flowing from the jets after 2 minutes, turn the
5. If the water is running smoothly through the lines, open the air control valve
to the jets and you should see an increase in jet pressure. Check and adjust
the water and airflow of every jet if necessary.
Each jet in your hot tub can be adjusted for massage intensity and
directional flow. Turn the outer jet dial counterclockwise to increase the
water volume and clockwise to turn it off. Pivot the angle of a jet to achieve
an optimal massage.
An air mixture intensifies the level of your massage. Turn the air control
valve counterclockwise to increase the air mixture and clockwise to turn it
off.
To minimize heat loss, close the air control valve when the hot tub is not in
use.
6. Press the Jets 1 button a third time to turn off the pump.
Do not use your hot tub!
power off at the main panel and bleed air from the system (see
page 47). Turn the power on again. Sometimes momentarily
turning the pump off/on will help to prime. Only do this 4 times.
For HELP, call 727.573.9611
Page 27