Premium Leisure Sterling Leisure Owner's Manual page 25

1. Turn on the breaker and test the operation of the Ground-Fault Circuit
Interrupter (GFCI) breaker by pushing the small button. This should
automatically trip the hot tub's circuit breaker.
DANGER: If this breaker does not trip, immediately call your electrician.
Only if pushing this button successfully trips this circuit breaker should you
reset this breaker and proceed to the next step.
2. Go to the topside control
panel and look at the
display. The system goes
through a brief startup
sequence after which
Pump 1 starts in filtration
mode and the panel
displays the current water
temperature.
3. Press the Pump 1 button
on a higher speed, see water circulating in the hot tub, see the icon swirl on
the display, and see CO in the VST Seat Control (see pages 37-40).
Caution: If water does not flow from the jets after 2 minutes, turn power
4. Press
and the icon swirl faster.
Note: Repeatedly pressing the button raises the speed each time (40%,
60%, 100%, and OFF
5. If the water is running smoothly through the lines, open the air control valve;
you should see an increase in jet pressure. Check and adjust the
water/airflow of every jet if necessary. Do this for all pumps to ensure proper
operation. Each jet
Turn the outer jet dial fully counterclockwise to permit water flow from a jet
and allow the VST system control intensity. Pivot the angle of a jet to
achieve an optimal massage. Adding an air mixture intensifies the le
your massage. Turn the air control valve counterclockwise to increase the
††
If the spa is in filtration or heating modes, the pump slows to 10% and does not turn OFF.
Do not use your hot tub!
off at the main panel and bleed air from the system (see page
47). Turn power on again. Sometimes momentarily turning a
pump off/on will prime it. Only do this four times.
again. You should hear the first pump turn on a higher speed
††
).
‡‡
in your hot tub can be adjusted for directional flow.
For HELP, call 727.573.9611
Figure 7 – Topside Buttons
. You should hear the first VST pump turn
Page 25
vel of
air