Hot Tub Submenus
Your hot tub can be programmed to specify how long it filters the water each day
(filter cycle). Four pages of menus control: when the filter cycle turns on/off (start
time), how long it runs each time it turns on (duration), how many times per day
cycles should run (frequency), and how much free chlorine (sanitation) should b
generated in a cycle (default is 12 a.m., 12 hours, 2 times/d
Note: W
hen our hot tub starts a filter cycle, the pumps turn on for about one
y
minute to purg
e the plumbing lines.
Start Press +/- to set the starting hour of the Filter Cycle, press > to
select minutes, and then press +/- to set th starting minute. Press
Duration Press +/- to set the duration of each Filter Cycle (i.e., whenever a
cycle runs, how long shou
screen. (12 hr cycle is recommended)
Frequency Press +/- to set the number of times each day the Filter Cycle runs
(2 recommended). Press
This submenu allows you to personalize operating settings
o
f your hot tub – such as the total filtration cycle, econ
times, and a maintenance reminder – and to display any
warning messages. When your hot tub is in a filter cycle, the
icon appears on the topside control panel.
Figure 24 – Filter Cycle Screens
to go to the next screen.
Page 32
For HELP, call 727.573.9611
ld it r
un). Press
to go to the next screen.
ay).
e
to go to the next
omy
e