Management Of The Pre-Designed Templates; Template Management - SMC Networks raptor User Manual

MANAGEMENT OF THE PRE-DESIGNED TEMPLATES

The Raptor system can carry out a lot of tests thanks to its measurement inputs, on the
one hand, and to its injection capacities, on the other hand. However, for these tests to
be able to be carried out comfortably, quickly and error-free, there must be a basic
method that is very easy for the operator to understand and apply.
That is what the Test Templates are. They allow the operator immediate access both to
the control and to the necessary measurements for each one of the tests proposed. The
system is automatically configured when a template is selected. The injection mode will
also be selected.
There are two types of Template:
Factory templates:
be used as they are or be edited by you.
User templates
own name to be used at any time. They can be created based on the Factory Templates
or directly.

Template management

screen and dragging.
You can choose: to create a new template; copy one of the
existing ones or use (load) one of the existing ones.
If you press New or Copy, you must enter a name and after
pressing accept, it will appear on the list. A new template
will be created in both cases, the difference being that if you
select "New" it will start with the basics, to start from zero, and in the case of "Copy", it
will inherit the configuration of the template selected to copy. Templates generated in
this way are totally configurable. Templates created by you can be deleted; the Factory
ones, on the contrary, cannot.
As a general rule, the Factory templates are associated with an injection mode and this
cannot be changed. The only exception is the template called General (or basic).
Already created by default and available at all times. They can
: These are Templates that the user can create and save with his
Access the template menu.
The management screen will
appear. You can move up
and down the list using the
dial or by tapping on the
Select a template and press Load. You will always see the
name of the current template at the top of the screen.
Users Guide
51