Functions Related To Measurement - SMC Networks raptor User Manual

Primary injection testing system

Table of Contents

Raptor

Functions related to measurement

measurements, in addition to the values shown on the chronometer and the binary input.

If it were already activated, by tapping on it, the meters would be released and the

currently measured values would be shown. This mode is activated automatically when

injection is stopped due to the Stop condition having been selected. With a new injection,

this mode is deactivated automatically.

Measurement averaging is for 5 seconds. However, this cycle re-starts as soon as the

variation of the measurement exceeds a certain threshold. Thus, even though this

function may be active, tracking in the event of changes is quick.

Hold button. After tapping on it, the values of the measurements

are

maintained,

Filter button. It allows activating the average of measurements,

thereby allowing them to be stabilised in noisy environments.

both

'Hardware'

and

'Calculated'

Table of Contents

Show Quick Links

Table of Contents

Do you have a question about the raptor and is the answer not in the manual?