Above, With the WiFi Function Dimensions: Size: L175×W44×H30(mm) Android (1.8MB), iOS (5.6MB) LINK: The indicator light stays lit when the mobile device connects to WiFi-103, and turns off when disconnect. Package Size: Language: L178×W48×H33(mm) English Category: Tool RX/TX: The indicator light turns on when WiFi-103 receives or transmits the WiFi data.
Page 3
Use code switch to set the controller's SSID Number, WIFI-103-SSID-X, X stands for a certain No. ranging 4.1 WiFi-103 Software Installation: from 0-F, totally 16 options. which means our product could set 16 isolated LAN in the same area. WiFi-103 Scan following QR code to download and install.
Page 4
-3-2) WiFi-103 Figure Figure RGB/CT/DIM driver setting In this connection mode, to avoid the mobile device automatically connect to WiFi-103 after the setting has Attn: Disconnect to Change the background WiFi-103 completed, please click on the connected WiFi-103 which under the mobile device "WiFi setting" and at the...
Page 5
WiFi-103 LED Controller WiFi-103 LED Controller 4.2.2 RGB/CT/DIM Driver Color Wheel Interface: 4.2.4. RGB Scene Interface Scene Currently selected On/Off Parameter values color Long Long press can change Parameter values press the background scene Brightness slider Color wheel Linear Toning...
Page 6
WiFi-103 LED Controller WiFi-103 LED Controller Tables of Changing Mode: 4.2.6 CT Mode Interface Mode Mode On CT interface, select color temperature by Modify the scene name touching color wheel, then click , scene 1~3 Cyan Fade Out and Fade In...
Page 7
DIY interface [Attn]: In direct connection of the WiFi-103 as a router. Please exit software after changed the SSID name and For Example: the password, then enter the mobile device system setting to reconnect the WiFi-103, In additional wireless router connection, it only needs to click “...
Page 8
Long press “MATCH” button on WiFi-103 (over 5s) till the buzzer long beep, means all the remotes learned with WiFi-103 cancelled. Attn: Different types of remote learning operation, will change WiFi-103 control mode directly (single color, color temperature and RGB mode).
Page 9
7.3 Connect By a Router Add T3-CV/T3-CC if needed. Method to Sync T3-CV/T3-CC to WiFi-103: Long press the “SCENE” button on the WiFi-103 controller until the buzzer long Learning ID: beep (RUN light flash quickly), and then short press the ID learning button on the T3-CV/T3-CC, the buzzer long beep again.
Page 10
WiFi-103 LED Controller WiFi-103 LED Controller 8. Attention 7.4 Remote Distance Reference 8.1 The product shall be installed and serviced by the qualified person. [Attn]: The following distance is measured at open environment, in unopened environment, testing wireless distance will be reduced. Please refer to the actual test distance before installation.
Need help?
Do you have a question about the WiFi-103 and is the answer not in the manual?
Questions and answers