How To Check Or Change A Programmed Recording (Timer) - Philips VR9010 Operating Instructions Manual

i
Switch off with the
STANDBY m
The programmed recording will only function when the
video recorder is switched off with the
button.
D If any of the TIMER blocks are in use, '
on the video recorder display.
D While a programmed recording is being made, you
cannot operate your video recorder manually. If you
want to cancel the programmed recording, press the
button.
STANDBY m
D If the video recorder is switched on a few minutes
before a programmed recording is supposed to
begin, 'SWITCH TO STANDBY - TIMER
RECORDING' will flash on the TV screen.
D If you reach the end of the cassette during a
recording, the video recorder will automatically
eject the cassette.
D If you forget to load a cassette, 'NO CASSETTE'
will appear on the TV screen and '
video recorder display.
D If you have put in a cassette which cannot be used
for recording, the video recorder will automatically
eject it.
D If `TIMER FULL´ appears on the TV screen when
you press the TIMER k
the available TIMER blocks. If you want to clear or
check a programmed recording (TIMER block),
press the P button and select the TIMERR block
with the or
;P
D Programme numbers 'E1' and 'E2' are for
recordings from other sources (through scart socket
or
EXT.1 AV 1 EXT.2 AV 2
button.
STANDBY m
k ' will light up
k ' will flash on the
button, you have used up all
button.
P =
).
How to check or change a programmed
recording (TIMER)
a
Switch on the TV set and select the programme number
for the video recorder.
b
Press the TIMER k button on the remote control.
The programming mode selected last is marked.
Select the line 'TIMER LIST' with the
c
button and confirm with the
d
Select the programmed recording (TIMER) you want to
check or change with the
e
Press the P button.
f
Select the entry field with the
g
Change any information with the
with the buttons.
0-9
D Under 'END', use the
recording speed 'SP' or 'LP'.
h
Confirm with the button.
OK
i
To end, press the TIMER k
j
Make sure that the cassette you have put in can be
recorded on. Switch off with the
D The programmed recording will only function when
the video recorder is switched off with the
STANDBY m button.
P = or ;P
button.
P
or button.
;P P =
or button.
Q P
P = or ;P button or
button to select the
SELECT
button.
STANDBY m button.
25