Table of Contents
Advertisement
D While a programmed recording is being made, you
cannot operate your video recorder manually. If you
want to cancel the programmed recording, press the
STANDBY m
button.
D If the video recorder is switched on a few minutes
before a programmed recording is supposed to
begin, 'SWITCH TO STANDBY - TIMER
RECORDING' will flash on the TV screen.
D If you reach the end of the cassette during a
recording, the video recorder will automatically
eject the cassette.
D If you forget to load a cassette, 'NO CASSETTE'
will appear on the TV screen and '
video recorder display.
D If you have put in a cassette which cannot be used
for recording, the video recorder will automatically
eject it.
D If `TIMER FULL´ appears on the TV screen when
you press the
TIMER k
the available TIMER blocks. If you want to clear or
check a programmed recording (TIMER block),
press the
P
button and select the TIMERR block
with the
or
P ;
D Programme numbers 'E1' and 'E2' are for
recordings from other sources (through scart socket
or
EXT.1 AV 1
EXT.2 AV 2
How to check or change a programmed
recording (TIMER)
a
Switch on the TV set and select the programme number
for the video recorder.
b
Press the
TIMER k
button on the remote control.
The programming mode selected last is marked.
Select the line 'TIMER LIST' with the
c
button and confirm with the
d
Select the programmed recording (TIMER) you want to
check or change with the
e
Press the
P
button.
f
Select the entry field with the
g
Change any information with the
with the
buttons.
0-9
k
' will flash on the
button, you have used up all
button.
P =
).
P =
or
P ;
P
button.
P ;
or
P =
button.
Q
or
P
button.
or
button or
P =
P ;
D Under 'END', use the
recording speed 'SP' or 'LP'.
h
Confirm with the
button.
OK
i
To end, press the
TIMER k
j
Make sure that the cassette you have put in can be
recorded on. Switch off with the
D The programmed recording will only function when
the video recorder is switched off with the
STANDBY m
button.
How to clear a programmed recording
(TIMER)
a
Switch on the TV set and select the programme number
for the video recorder.
b
Press the
TIMER k
button on the remote control.
The programming mode selected last is marked.
Select the line 'TIMER LIST' with the
c
button and confirm with the
d
Select the programmed recording (TIMER) you want to
clear with the
P =
or
e
Press the
button.
CLEAR (CL)
f
Confirm with the
button.
OK
g
Switch off with the
TIMER k
'NexTView Link'
This video recorder is equipped with the function 'NexTView
Link'. If your television is also equiped with this function, you
can mark TV programmes on the television for programming.
These TV programmes will automatically be transmitted to a
TIMER block on the video recorder. If you clear the marking of
the TV programme on the television, the corresponding TIMER
block on the video recorder will also be cleared.
For more information, read the instruction manual of your TV
set.
button to select the
SELECT.
button.
STANDBY m
button.
P =
or
P ;
P
button.
P ;
button.
button.
21
Hide quick links:
Advertisement
Table of Contents
