Connecting Without A Scart Cable; Connecting A Decoder Or Other Equipment - Philips VR9010 Operating Instructions Manual

D If your TV set does not switch to programme number
e.g.: 'EXT', '0', or 'AV' automatically, select the
programme number for the video recorder manually
(see instruction manual TV set).
h
Then read 'Initial installation' in chapter 'INSTALLING
YOUR VIDEO RECORDER'.

Connecting without a scart cable

a
Switch off the TV set.
b
Remove the aerial cable plug from your TV set and insert
it into the 2 socket at the back of the video recorder.
c
Plug one end of the aerial cable provided into the
socket on the video recorder and the other end into the
aerial input socket on your TV set.
d
Insert one end of the mains cable into the mains socket
4 at the back of the video recorder and plug the other
end into the wall socket.
e
Switch on your TV set and select the programme number
that you have chosen for video playback (see instruction
manual TV set).
f
Tune in the TV set until this picture appears.
D The video recorder will now be sending a
welcoming text on channel 35 or 583MHz:
CONGRATULATIONS ON THE
PURCHASE OF YOUR NEW
PHILIPS VIDEO RECORDER
TO CONTINUE PRESS OK
6
g
When the TV has been tuned read the paragraph 'Initial
installation' in the chapter 'INSTALLING YOUR VIDEO
RECORDER'.

Connecting a decoder or other equipment

You can connect additional equipment to the
socket. For example: a decoder, a satellite receiver or a
camera recorder.
You can connect a HIFI-stereo set to the sockets
(audio output left/right) and
AUX OUT L R
input left/right).
3
EXT.2 AV 2
(audio
AUX IN L R