Guide For Operation- General Operation; Guide For Operation- Optional Operation; Changing Batteries And Notices - INVENTOR Cool 8000btu Instruction Manual

Guide for operation- General operation

1. After powered on, press ON/OFF button, the unit will start to
run.
2. Press MODE button, select desired running mode,
3. Pressing + or - button, to set the desired temperature. (It is
not possible to set the temp. at AUTO mode.)
4. Pressing FAN button, set fan speed, can select AUTO, FAN
1, FAN 2 or FAN 3.
5. Pressing SWING button, to select the swing. (This function is
unavailable for this model).

Guide for operation- Optional operation

1. Press SLEEP button, to set the unit to sleep mode.
2. This function can be cancelled on pressing the sleep button
again when the unit is on sleep mode.
2. Press TIMER button, can set the scheduled timer on or timer
off. ( Please refer to the operation of the wireless remote on
instructions to use the timer function )
Changing Batteries
1. Place the remote face down on a flat surface
2. Unclip the battery cover and remove the cover.
3. Take out the old batteries. (As show in figure)
4. Insert two new AAA1.5V dry batteries, and pay attention to
the polarity. (As show in figure)
4. Attach the back cover of wireless remote control.
NOTE:
★
● When changing the batteries, do not use the old or different
batteries, it may cause malfunction of the wireless remote
control.
If the wireless remote is not used for a long time, please take
●
the batteries out to check for leakage, do not let the leakage
liquid damage the wireless remote control.
The remote should be in the unit's operating range and
●
directed towards the sensor on the unit.
● It should be placed at where is 1m away from the TV set or
stereo sound sets.
If the wireless remote control can not operate normally, please
●
take them out, after 30s later and reinsert, if they cannot
normally run, please change them.
11