Light / Winker Inspection; Inspection Of Stop Lamp; Bulb Replacement Method - DAELIM Q2 Owner's Manual

LIGHT / WINKER INSPECTION

HEADLIGHT, TAIL LIGHT
Start the engine and operate switches whether the lights
turn on or not, and simultaneously check whether the
lens of lights being contaminated or not, whether they
are damaged.
CAUTION
The lighting head light emits very hot
●
heat. If you touch with naked hand, it
may be burned.
When replacing head light lamp, stop
●
lame and winker lamp, use only a bulb
of rated capacity. Using a lamp
exceeding the rated capacity can cause
over-discharge of battery and wire
burning. It can lead a fire.
If the head light is turned off due to
●
aging while driving at night, it will cause
an accident by obstructing driver's view.
Check the condition daily.
If the tail light is off while driving at
●
night, it will cause an accident by failure
of notice by the other drivers. Check the
condition daily.
INSPECTION OF WINKER
Turn a main switch (ON) . By operating winker
switch, check whether the front-rear-left-right lamps
are exactly operated or not, and simultaneously the
operating sound of winker works or not
In addition, check whether lens are dirty or damaged
(cracked) or not.

INSPECTION OF STOP LAMP

Turn a main switch (ON) . Check a stop lamp for
proper operation by operating the front wheel and the
rear wheel brakes, and also a lens for damage or
contamination.

BULB REPLACEMENT METHOD

Be sure to turn a main switch (OFF) prior to
●
replacing of a bulb.
Use only a bulb of rated capacity.
●
After replacement with new bulb, check for proper
●
operation.
CAUTION
Care is to be taken to avoid leaving
●
fingerprints on a headlight bulb. Failing
to observe this may cause early damage
of the headlight bulb resulted from
concentration of heat.
Be sure to wear clean gloves when
●
replacing a bulb. If touched to it with
bare hands, clean it with a cloth soaked
with alcohol to prevent from early
damage.
REPLACEMENT OF HEAD LIGHT
[
BULBS
]
Loosen 4 socket bolts and remove the windscreen.
①
Untie 7 tapping screws and remove the front cover.
②
③ Untie 8 tapping screws and 2 bolts and remove
the front under cover.
SOCKET BOLTS
●
WASHER BOLTS
●
TAPPING SCREWS
●
BLACK : FRONT ASSEMBLY
RED : REAR ASSEMBLY
29