Basic Operations; Reverb/Delay Tail Spillover - HEADRUSH Pedalboard User Manual

Basic Operations

Important: The sequence of models in your signal chain is not necessarily reflected in the footswitches. You can
freely assign models to available footswitches without changing your signal chain at all—and vice versa. See
Hardware Assign to learn about this.
To assign a model (amp, cab, or effect) to an empty slot, tap it () and then use the list
that appears. See Rigs > Creating a Rig
To show a model's parameters on the right edge of the screen, tap the model so it is
outlined in green. You can then turn the parameter knobs to adjust the parameters to
their left. Tap anywhere in the column of those three parameters to show the next three (if
the model has more than three parameters).
When no model is selected, these parameters will be ones that you assign in the
Hardware Assign screen.
To show a model's settings screen, double-tap it. Its settings screen will appear with
its preset menu, parameters, and assigned color.
To activate or deactivate a model, press the footswitch assigned to it, or tap the
model's footswitch in the display.
To switch an amp and/or cab between a dual and single configuration, tap the 2X button next to it.
To load another rig (preset), do any of the following:
• Press the upper-left (Rig ) or lower-left (Rig ) footswitch to load the previous or next rig immediately.
• Tap the name of the rig on the screen, and then tap the  or  next to it.
•
Tap the name of the rig on the screen and then turn the encoder.
•
Tap the magnifying-glass icon in the upper-left corner, and use the virtual keyboard that appears to
enter a search term (e.g., part of the rig name). The results will appear below. Tap a result to load that rig.
To create a new rig, tap the  button in the upper-right corner, and then tap New Rig.
To delete the current rig, tap the  button in the upper-right corner, and then tap Delete Rig, and then tap
Yes to continue or No to cancel.

Reverb/Delay Tail Spillover

If you have a reverb or delay effect active on your rig and then switch to a different rig, the reverb or
delay will continue to decay after switching to the second rig.
This feature is unavailable if you are using an effects loop or if you are using USB audio.
To enable or disable this feature for the current rig, tap Tail on the main screen. Alternatively, press
and hold the upper-left (Rig ) footswitch for one second.
to learn about this.
To rearrange the
models in your signal
chain, tap and drag a
model to another slot
or between two other
models (the ones after
that position will shift
one slot further down
the signal chain).
9