Footswitches; Quick Parameters - HEADRUSH Pedalboard User Manual

Footswitches

The eight boxes in the lower-left corner represent the middle eight footswitches of the HeadRush Pedalboard.
You can assign any switch-based parameters (ones with only two states) to any of the footswitches—regardless
of their location in the signal chain.
To assign a parameter to a footswitch:
1. Tap a box.  indicates an empty box.
2. In the list that appears, tap the model with the parameter you
want to assign.
3. In the list that appears, tap the parameter you want to
assign. Usually, the parameter will simply be On (to activate
or deactivate it).
Tap Unassigned  to unassign that footswitch.
4. On the Hardware Assign screen, tap Toggle/Hold for that
footswitch to determine how it works.
When set to Toggle, each press will turn the model on or off.
When set to Hold, pressing and holding the footswitch will
activate it, and releasing the footswitch will deactivate it.
To swap two assignments, tap and drag one of them over the
other, and then release it.

Quick Parameters

The right edge of the screen shows a column of fields for three parameters. These are the three parameters
that are shown first whenever you load a rig. When no model is selected on the main screen, you can turn
the three parameter knobs to adjust these parameters. You can assign any continuous parameters to
these knobs (parameters with a range of values rather than ones with only "on" and "off" states).
To assign a parameter to a parameter knob:
1. Tap the field to which you want to assign a parameter.  indicates an empty field.
2. In the list that appears, tap the model with the parameter you want to assign. You can also select
parameters for the incoming signal (Input) or outgoing signal (Output).
3. In the list that appears, tap the parameter you want to assign.
Tap Unassigned  to unassign that parameter knob.
20