Out; Mix; Saving A Preset - HEADRUSH Pedalboard User Manual

Out

These output settings control the signal sent to the HeadRush
Pedalboard outputs:
Preset: This is the current output preset, which includes
its settings on the right edge of the display.
Rig Output: This level meter indicates the current level of
your output signal after the output controls shown on
this screen. You can set which outputs will send this
signal in the Global Settings screen. See
to learn about this.
Alternate Output: This level meter indicates the current
level of your output signal. You can set which outputs will
send this signal in the Global Settings screen. The To
Amp Gain setting controls the level of this signal unless
the Alternate Output source is set to Rig Input. See
Global Settings to learn about this.
Rig Vol (Volume): This setting controls the level of the audio signal sent from the outputs. The available range
is -60.0 to 36.0 dB.
To Amp Gain: This setting controls the gain level of the signal of the Alternate Output unless the Alternate Output
source is set to Rig Input (see
Rig Width: This setting controls how much of the stereo field the output signal uses. 100% uses the full stereo
field, while 0% produces a mono signal. This affects stereo signals only, not mono signals. See
> Stereo vs. Mono

Mix

These settings control mix of a split signal path. This is
available only for rigs with split signal paths (see
> Signal Path to learn more):
Preset: This is the current mix preset, which includes its
settings on the right edge of the display.
A Lev / B Lev (Level): These settings control the volume
levels the upper (A) and lower (B) branches of the signal
path. The range is -60.0 dB to +12.0 dB.
A Pan / B Pan: These settings control the panning (position
in the stereo field) the upper (A) and lower (B) branches of
the signal path. The range is -100% to +100%.
A/B Delay: This setting controls a timing offset between the upper (A) and lower (B) branches of the signal
path. The range is -30000μs to +30000μs. If the value is negative (-), the A branch is delayed. If the value is
positive (+), the B branch is delayed.

Saving a Preset

To save a preset, tap Save in the upper-right corner.
To save your changes to the current preset, tap Save.
To save your changes as a new preset, tap Save New
Preset, use the keyboard that appears to enter a name,
and then tap Save.
To return to the previous screen without saving, tap Cancel at any time.
Global Settings
Global Settings
to learn how the HeadRush Pedalboard handles stereo and mono signals.
to learn about this). The available range is -60.0 to 12.0 dB.
Main Screen
Main Screen
18