Global Settings - HEADRUSH Pedalboard User Manual

Global Settings

Use the global settings to configure the
HeadRush Pedalboard's overall operation.
To show the global settings, tap the 
button in the upper-right corner of the screen,
and tap Global Settings.
LCD Brightness: This setting determines the brightness of the main display. Tap this field, turn the encoder to
select 1 (dim) through 5 (bright), and then press the encoder.
Audio Configuration:
Rig Input: This setting determines whether each rig's input signal is taken from the guitar input (Guitar) or the
right (R) return input (FX Ret R). When set to Per Rig, the source is determined by the Rig Input setting of
each rig (see Adjusting Settings > In
Stereo Return setting will be disabled; the signal will be mono.
FX-Loop Stereo: These settings determine whether the incoming and outgoing signal in the effects loop is
stereo or mono. Tap Send to enable or disable the stereo signal for the send outputs. Tap Return to enable
or disable the stereo signal for the return inputs.
Alternate Output: These settings determine the signal sent from each output.
Source: This setting determines the point in the signal path from which the alternate output signal is taken:
Rig Input, Amp Input (the default setting), Amp Output, Cab Input, Cab Output, IR Input, Amp 2 Input,
Amp 2 Output, Cab 2 Input, Cab 2 Output, or IR 2 Input.
XLR Out: This setting determines whether the XLR outputs will send the rig output signal (Rig) or alternate
output signal (Alt).
Amp/Line Out: This setting determines whether the 1/4" (6.35 mm) outputs will send the rig output signal
(Rig) or alternate output signal (Alt).
Phones Out: This setting determines whether the phones output will send the rig output signal (Rig) or
alternate output signal (Alt).
Pedal Configuration:
External Pedal: This setting determines whether or not you are using an external expression pedal with the
HeadRush Pedalboard.
Tap On to use the built-in expression pedal to control the parameter/parameters of Bank A while your
external expression pedal controls the parameter/parameters of Bank B. (If you are using the expression
pedal's Classic Mode, pressing the toe switch will activate or deactivate the parameter. If you are using
Advanced Mode, the toe switch will be disabled entirely.)
Tap Off to disable the expression pedal input and use the built-in expression pedal only.
to learn about this). When set to FX Ret R or Per Rig, the FX-Loop
25