Hands-Free Mode; Looper - HEADRUSH Pedalboard User Manual

Hands-Free Mode

Hands-Free Mode enables you to adjust any of the settings on your
models by using just the footswitches and expression pedal.
To enter Hands-Free Mode, press and hold a footswitch assigned
to a model for over one second. While in Hands-Free Mode, the
screen will show a single parameter and its value, and the top six
footswitches will correspond to six parameters of that model.
To exit Hands-Free Mode, press the lower-left most (Exit) footswitch.
To change the value, move the expression pedal.
To show another parameter, press the corresponding footswitch. If
that model has more than six parameters, press the lower-middle two
( or ) footswitches to show the previous or next six parameters.
If you are using a double-amp and/or double-cab configuration (2X),
use the 12 footswitch to switch between the two.

Looper

The HeadRush Pedalboard has a built-in looper that you can use to layer your performances. While the looper's
operation is shown in the display, you can control most of it conveniently with the footswitches.
The looper can hold up to 20 minutes of audio at a time across a maximum of 100 layers.
This meter indicates
your current
location in the loop
during recording or
playback.
This indicates the
current speed of the
loop as a multiple or
fraction of the
original.
This indicates how many layers are playing in the
current loop, including the original.
Rig name.
This indicates the direction of
playback.
This controls how much
of the looper's signal you
hear in the outputs.
This controls how much
of the looper's signal is
routed back through it
when recording another
layer.
This indicates the length
of the current loop.
23