Cochran commander+ Owner's Manual page 14

decays to 2.3 volts, the "BATT" legend will begin to flash on and off. Also, the TACLITE
if on, will be turned off to conserve the remaining battery power even though the unit
may be on a dive. While there should be sufficient battery power to normally complete a
dive, it is not recommended to begin a new dive until fresh ENERGIZER brand batteries
®
are installed. After the computer automatically turns itself off 40 minutes after a dive, it
cannot be turned back on if the battery voltage is less than 2.3 volts. Fresh
brand batteries must be installed. See the "BATTERY CHANGES"
ENERGIZER
®
section of this manual for detailed information on how to change batteries.
CAUTION!!! COMPLETE LOSS OF BATTERY POWER WILL CAUSE ALL PREVIOUS
DIVE NITROGEN LOADING TO BE LOST. THIS WILL AFFECT NITROGEN
CALCULATIONS ON NEAR-FUTURE DIVES. AFTER A BATTERY CHANGE,
CONFIRM THAT NO-DECOMPRESSION TIME DATA IS REASONABLE DURING
PRE-DIVE PREDICTION MODE. DIVE-OF-DAY NUMBER GOING TO ZERO
IMMEDIATELY AFTER CHANGING BATTERIES IS ANOTHER INDICATION OF A
LOSS OF NITROGEN LOADING.
12
SIDE CONTACTS: For identification purposes, put the COMMANDER+ face up in the
orientation that allows the display, display bezel, and product name to be read. There
are three contacts on the right side of the unit. The closest contact toward the bottom of
the display is Contact 1, the middle contact is Contact 2, while the contact farthest away