Page 1
Cochran EMC-20H Air Only Owner's Manual English - Imperial Ver: CmdrEMC-20H Air-1.00 For your records, please fill in the following: Serial Number: _________________________ Your Name: ____________________________ Your Contact: __________________________ ______________________________________ ______________________________________ Purchase Date: _________________________ Purchase Place: ________________________ Address: ______________________________...
When there is no remaining Nitrogen residual, the Dive The EMC-20H will not turn on if the altitude is higher than 16,000 feet, the of Day is set to zero and the computer is referred to as a “clean” system.
75 degrees F. depth. Bottom Time will begin once the EMC-20H senses that the diver has The Remaining No-decompression Time and “NDC” legend will be descended below five feet (see Training Mode) and continues until the replaced with Decompression Time and “DEC”...
Clock Mode the Dive Computer will be in the “Sleep” mode. minutes if the unit is in the Training Mode) after a dive, the EMC-20H is in The Clock Mode can be selected with or without an Alarm. If the Alarm the Post Dive Interval.
TACLITE™ On Time. Allowed value 0 to 99 Logbook NOTE: Once the EMC-20H is placed in Clock Mode the unit will remain in that mode until exited by the diver. TOUCH PROGRAMMING MODE: NOTE: To enable the Programming Mode, the EMC-20H must be on the Surface and not in the Post Dive Interval.
The Taclite™ dwell (on) time can be set so that when the face on the EMC-20H is tapped the Taclite™ will stay on from 1 to 98 seconds. If the dwell time is programmed to ‘0’ the Taclite™ will never come on, if programmed to 99 the Taclite™...
If an audible alarm is being issued, the computer will not switch to the Alternate display nor will the TACLITE™ activate. SENSOR WARNING: The EMC-20H has the capability of monitoring the integrity of its' sensors, both the low-pressure (depth/altitude) and the temperature.
This option enables the Training Mode for the EMC-20H. In this mode Ascent Rate Responsiveness (0 to 7): This option determines the the EMC-20H will enter the Dive Mode at 2 feet instead of 5 feet and exit responsiveness or sensitivity of the Ascent Rate Bar Graph. Zero is the Dive Mode at 1 foot instead of 3 feet.
If the batteries are allowed to discharge too low, or if removed for too Decompression Ceiling 0 to 410 feet, 10-foot increments long, the EMC-20H may enter a state where it will not turn on even with Dive Summary Storage up to 1024 Dives new batteries.
INTERFERENCE STATEMENT cold, or other conditions which COCHRAN may deem to be outside the NOTE: This equipment has been tested and found to comply with the intended scope of this Limited Warranty are not covered. This Limited limits for a Class B digital device.
Should it be desired to initiate a dive PRIOR to completing the adaptation No Cochran Undersea Technology dealer, agent, or employee is time, the EMC-20H will treat this dive as a repetitive dive in its algorithm, authorized to make any modification, extension, or addition to this taking into account the "residual"...
TABLE OF CONTENTS FIGURES INDEX Page Number Fig # Page Number Product Introduction Side Touch Contacts Self-Test Screen Turning the Product On & Off Surface Interval - Primary Screen - No Nitrogen Main Operating Modes Surface Interval - Primary Screen - With Nitrogen Surface Interval 10a Dive Mode Dive Mode...
Page 15
Cochran EMC-20H Air Only Owner's Manual English - Imperial Ver: EMC-20H Air-2.00 1758 Firman Drive Richardson, Texas 75081, USA Phone 972-644-6284 972-644-6286 www.divecochran.com...
Need help?
Do you have a question about the EMC-20H and is the answer not in the manual?
Questions and answers