Philips DTR3030M User Manual page 52

Philips DTR3030M
1.4 Receiver installation for the first time
When you finish connecting the receiver (para. 1.2.2) and then connect to the mains power supply, the receiver
will start up automatically. If it does not happen, turn on the device using the
of the front panel. Screen then displays a simple procedure guide for the first time installation.
NOTE
Use the arrow buttons , , ,
the button OK at the Next entry to confirm and proceed.
Follow the instructions below:
Language Choice
Choose the language of the menu on the screen. (OSD-On Screen Display), of the Main Audio and Main
Subtitles.
Time Adjustment
Set the country of installation and set the time according to the reference of Greenwich (Italy GMT + 01:00)
and the Summer Time option, it is recommended that you keep automatic (Auto).
PIN Definition
Define a four-digit numeric password (PIN-Personal Identification Number) for parental control (see also the
section 3.6.3). Enter the PIN you chose in the field New PIN, and then reinsert it into PIN Confirmation to
confirm it.
Audio Settings Page
Configuring audio and video parameters of the receiver according to the characteristics of the audio/video
devices connected to the receiver:
Resolution: settings of video resolution of the audio- video digital HDMI interface
1.
2. Size: format of screen/TV connected to the receiver and its mode of images presentation with different
format from the screen:
a. 16: 9: for 16: 9 screens, 4: 3 images will be adapted to the entire screen.
b. 4: 3: for 4: 3 screens, 16: 9 images are adapted to the entire screen.
3. SCART output: type of video output of SCART (RGB, CVBS) output
4. Dolby Digital: encode of digital audio output between original source (RAW) and Digital Stereo (PCM)
and Multichannel (Dolby Digital).
Channels-LCN
Choose whether to use (recommended) the function of the auto-numbering channels (Logical Channel
Numbering – LCN), through which the channel list will be sorted automatically according to the location required
by same broadcasters.
Channels-Scan
If you use an active antenna to be supplied with 5V
input of the receiver, press the red button (5V Antenna) to activate(ON); press it again to turn it off (OFF).
WARNING
If you use a classical roof antenna or an antenna already energized, antenna power must necessarily cut off:
risk of overload!
Keep Scan Mode in Auto e (automatic) and start auto search by pressing the OK button of the remote control
corresponding to the tone Forward.
After the scan, you may meet the LCN conflict. In this case, if two or more channels require the same number
in the channel list, the user shall choose the one to avoid conflict. Then highlight the desired service by moving
with arrow buttons /
conflict; alternatively, for the automatic assignment of the system, press EXIT or wait a few seconds without any
choice.
Result
After completing the above steps, and then install, confirm with OK consultation and you will immediately enjoy
digital terrestrial channels available, and Applications via the internet portal and Media Player.
NOTES AND WARNINGS
Some channels may be not visible, due to encoding or not compatible with this receiver.
During the life of the receiver, the channels could become obsolete or change the transmission
parameters. We recommend that you keep updated the channel list (section 3.1.1).
o always get a quick switch on of the receiver in power standby state, you must disable the Power Saving
in the menu Settings > Receiver Configuration> Power Management (par. 3.6.1.5).
8
on the remote control to switch between voices and menu options, then press
(sign)press OK to confirm, then press OK again on OK item. Proceed thus for every
, through the coaxial cable connected to RF IN antenna
button on the remote control or