Philips DTR3030M User Manual page 51

7. After programming of all buttons you want, press the TV button again to save the program and exit the
learning mode.
NOTES AND WARNINGS
The individual buttons programmed by using the learning function will always be associated with the
function, even if you change the code by choosing among predefined TV. To clear the learned function,
you must restore to factory settings (reset) of the remote control, as described in section 1.3.3.5.
Before learning programming, it is recommended to use new batteries for both remotes.
The buttons TV, STB and SOURCE are not programmable through learning.
1.3.3.5 Restore factory settings (reset) of the remote control
If necessary, you can reset the remote to original factory settings as follows:
Press the TV button for more than 3 seconds until the LED indicator remains lit on the remote, then
1.
release it.
2. Press and hold the
SOURCE button until the LED indicator off: reset is completed.
3. Press the
NOTE
The reset will restore the default programs/TV codes from the factory, bringing the TV program the value 0000
and removing any button programmed through learning.
1.3.4 Use of the remote control
After the remote control of TV is programed, it will work just like the original TV remote control, at least with
the basic functions such as switching on and off, adjusting audio volume and channel change. To control the
decoder or the TV, short press on the corresponding STB or TV function buttons and point the remote control
at the IR sensor of the related device. During the transmission of each remote control, their LED indicators will
illuminate.
SOURCE button for about 3 seconds until the LED starts to blink.
Philips DTR3030M
7