Installation Procedures; 四.安裝步驟 - Pacific PR-2107 Use, Care And Installation Manual

IV. Installation Procedures
Warning: Electrical wiring must be handled by a professional electrician.
The range hood must be connected to a ground outlet. Before doing any
electrical work, please be sure to turn off the power supply.
1. Measure the distance between the top of the stove and the bottom of the
range hood (see figure , Point A). Make marks on the wall (at least 24 inches).
2. Measure the center point, and mark on the wall.
3. Measure the distance between Point A and Point B, and mark these on the
wall ( about 16 inches)
4. Make two marks on Point B where the two screws will be (about 12.6 inches)
5. Put the two M4 X 1-1/2" screws in the wall, but not securely tightened.
6. Remove the two aluminum mesh filters on the bottom of the range hood.
7. Hang the range hood on the two screws that have been installed in the wall
and then tighten the screws (see picture A).
8. Use the two M4 x 1" screws to secure the pipe-cover bracket.
9. Install the power cord and exhaust pipe.
10. Turn on the power supply and test if the hood is working and if air is moving
through the exhaust pipe outlet.
11. Use two M3.5x8" to secure the top part of the pipe-cover to the bracket,
then install the bottom part. Put the two aluminum mesh filters back in.
12.6 in
central line
16 in
picture A
24 in
4.
四.安裝步驟
警告:電力接線方面必須由專人處理，抽油煙機必須接上地線。
接線前請務必確保電源開關以關閉
1. 測量爐檯面至油煙機底部的高度，如圖中的A線，後標記在牆上。(最少24吋)
2. 測量中間線，標記於牆上。
3. 測量A線至B線的距離，標記在牆上。(約16吋)
4. 測量兩個在B線的螺絲鎖點標記於牆上。(約12.6吋)
5. 將兩個M4x1-1/2" 固定於牆上，但先不鎖死。
6. 移除底下兩片鋁網。將不鏽鋼板放置機箱頂板上，鎖上四個3/16x1/4"螺絲。
7. 將油煙機掛上先前鎖上牆的兩個螺絲上，後將螺絲鎖死。(如圖A)
8. 利用兩個M4x1"螺絲固定風管飾板固定片。
9. 安裝電源線和風管。
10.開啟電源測試並檢查風管外是否風外洩。
11.用兩個M3.5x8"安裝固定上半部的風管飾板至固定片後安裝下半部。
最後裝回兩片鋁網。
12.6 in
16 in
圖A
24 in
4.