Advertisement
IV. Installation Procedures
1. Prepare duct location on hood (vertical).
2. Measure and cut out duct and electrical
openings in cabinet or wall to match up
with the hood. Ducting and electrical
dimensions can be found on Page 1.
Note: Makesure duct opening is large
enough to apply aluminum duct tape.
3. Reinforce cabinet bottom with wood strips
if additional strengthening is required or
if cabinets are framed.
4. Remove bottom panel from hood using
a Philips head screwdriver to remove
each of the (5) screws.
5. Stick the two round rubber stands on the
sides of hood's top. (see Fig 2)
6. Install (4) wood screws to cabinet bottom
These screwswill be used to secure the
hood to the cabinet.
7. Lift hood onto screws located on cabinet
bottom and lock into place. Make sure
all (4)key-holes cover the screws. Tighten
each screw to secure hood to cabinet.
8. Install electrical.
9. Install duct work and seal with aluminum
duct tape.
10. Power up hood and check for leaks around
duct tape and test all functions.
11. Reinstall bottom panel and re-connect
lighting harness.
12. Install oil cups into their openings on the
bottom of the hood and re-install the
stainless baffle filters into the hood.
Duct cover
mounting
bracket
4.
Fig 1
Fig 2
Advertisement
