Table of Contents
Advertisement
3.1.2 Problems related to printing(part 002/2)
4 Data sent from the host
is not printed at all.
Data cannot be received
from the host.
Symptom
Printing operation is not
performed at all.
Self-test printing is
performed normally.
Even self-test printing is not
performed.
Paper out condition is
detected.
REMOVE PAPER indicator
blinks.
Cause
The interface cable is
not connected
properly.
The front cover is
open.
The host interface
setting of the printer
does not match the
host used.
The interface is
defective.
The carriage cable is
improperly connected
to the print head or
control board.
The control board is
defective.
Paper pass select isn't
correct.
Paper isn't load.
CSF is empty.
Cut sheet leaved on
the paper table and
printer waiting
removing it.
24
Response
Connect the interface
cable properly.
Close the front cover.
Enter setup mode and
change the setting for
the host interface.
• Replace and initialize
the control board.
• Replace the interface
cable.
• Check the host.
Connect the carriage
cable properly.
Replace and initialize
the control board.
Remove the paper from
the paper table.
Advertisement
Table of Contents
