Fluke 810 User Manual page 152

810
Users Manual
Table B-1. 810 Vibration Tester Warning and Error Messages (cont.)
Display Message
Failed to perform self test This message shows during the self-test. The Tester is defective. Contact the Fluke Service
Center for technical support.
Data transfer not successful This message shows if the Tester cannot connect to the Viewer software. Make sure that the
connection is good between the Tester and computer.
Contact Fluke Service An error occurred in the Tester. Turn the Tester off and then on. If the message is frequent,
Center contact the Fluke Service Center for technical support.
Table B-2. Viewer Software Warning and Error Messages
Display Message
Application encountered an An error occurred in the Viewer software. Restart the Viewer software application.
error.
Invalid file The Viewer software cannot read the file type.
Installation file format is The upgrade file is defective or invalid.
wrong
Tester connection is lost This message shows if the connection breaks between the computer and the Tester during
data transfer. Correctly connect the USB cable.
B-4
Description
Description