Table of Contents
Advertisement
STEP 4
Install the Saddle (7) to the Saddle supporting tube (5) with
the Flat washers (32) and Nylon nuts (33).
Pull up the Knob bolt (29) then insert the Saddle supporting
tube (5) to the Main frame (1) and screw Knob bolt (29).
Note : You can control the Knob bolt (29) to adjust the ap-
propriate height which is suitable for you.
STEP 5
Attach the Pedals (10L/R) to the Cranks (35L/R) of the Main
Frame (1).
Note: The left pedal (10L) should be tighten in the counter-
clockwise direction, the right pedal (10R) should be tighten
in the clockwise direction.
STEP 6
Connect the Extended wire (21) and Pulse sensor wire(27)
with the wire on the Computer (9). Finally fix the Computer
(9) onto the top of the Front vertical tube (4) with Screws
(34), Flat washers (34).
Now, your machine is ready for use.
7
Advertisement
Table of Contents
